Light duty replacement roller used on all Salty Dog Marine diamond wires.

This roller will slide over the 1/8” (3.2mm) diamond wire turnbuckle
studs found on most catamarans. Remove the turnbuckle and lock nut,
slide the roller over the stud and onto the diamond wire and re-install
the lock nut and turnbuckle. Adjust and tighten the lock nut.

Note - Additional clearance will be required for the 5/32” (4mm) diamond
wires found on bigger catamarans (Hobie Cat 21SE). The center hole
of the roller will require additional clearance which can be obtained
with a drill motor and 5/16 (8mm)” drill bit.

Injection Molded Plastic
Inside Diameter: 17/64” (7mm)
Outside Diameter: 2” (51mm)
Width: 25/32” (20mm)
Weight: 1 oz (28g)
50-6174000 - 50-6174000 - 61740000