A replacement dolphin striker wire for the upgrade kits which were used to turn a standard Hobie Cat 14 into a Hobie Cat 14 Turbo with a jib.
Note - To our knowledge there were 2 different kits, including the Hobie Cat Co. kit, where the dolphin wire striker wire had wire fork ends. We require the pull-to-pull measurement in order to make sure you are getting the proper wire.

Pull-to-Pull Measurement - If you put a screw driver blade in each thimble (loop on each end of the wire) or in each hole of the wire eye / fork end, pull the wire tight and measure to the OUTSIDE of each screw driver blade (bearing surface, inside of thimble to thimble or hole to hole) that is the pull to pull measurement we use to build wires.

New white vinyl coated wire constructed of 5/32" (4.0mm) 1x19 stainless wire. Each end is roller swagged with a wire fork end.

302/304 Stainless Steel (Wire)
316 Stainless Steel (Fork Ends)